Aluminium Plate
Aluminium Plate Temper Codes
Stock Range
| Code | Description |
| H111 | Strain hardened less than the amount required for a controlled H11 temper |
| H112 | No special control overa mount of strain hardening. Some minimum strength limits set. |
| H321 | Strain hardened less than amount required for a controlled H32 temper. |
| H116 | Acceptable resistance to stress, cracking and exfoliation attack. Strain hardened less than amount required for a controlled H32 temper. |
| H321/H116 | Plate can be supplied with a dual temper from select mills. |
| H32 | Strain hardened by rolling and then stabilising heat treatmenet to ¼ hard. |
Stock Range
| Alloys | 5083, 5383, 5005, 5052, 5454, 5186 |
| Tempers | H32, H34, H116, H321 |
| Thickness range | 4 to 25mm |
| Width range | 1200 to 2500mm |
| Length range | 2400 to 12000mm |
Note: Through our processing facilities (Atlas Metal Processors) , all plate product can be slit and cut-to-length for specific requirements. Linishing is also available.
Finishes
Eval Bright transport plate: this material is sourced from a select mill. Atlas market and stock this quality of plate in alloy 5083, temper H32.
Mill Finish: this refers to plate supplied ex mill with a commercial finish. This material is typically used in the marine industry, general engineering and transport industry where bright plate is not critical.
Finishes
Eval Bright transport plate: this material is sourced from a select mill. Atlas market and stock this quality of plate in alloy 5083, temper H32.
Mill Finish: this refers to plate supplied ex mill with a commercial finish. This material is typically used in the marine industry, general engineering and transport industry where bright plate is not critical.
Bending radius chart [24.81kb]This chart displays the recommended minimum inside bending radii for 90 degree cold forming of sheet and plate.
